WS8610 Additional Sensors
If you want to add more remote sensors to the WS8610, you must go through the following steps BEFORE putting the batteries in the remotes:
- Mark the first logger [1]
- Follow the instructions: Learning a transmitter (channel) to set up the channels you wish to use (say 3)
- Follow the instructions: Setting the number of transmitters to be saved into the system memory.
Once this has been done, put the batteries in the second remote sensor and notice that a symbol of concentric arcs of a circle appears again - showing that the sensor is communicating with the logger. At the same time, the logger number [2] will be displayed on the main screen. Mark the logger [2]
Once this has settled down, repeat this for the third remote sensor, noting the communication symbol and the logger number [3]. Mark the logger [3]
The unit will then be receiving signals from each of the remotes.
- Follow the instructions: Learning a transmitter (channel) to set up the channels you wish to use (say 3)
- Follow the instructions: Setting the number of transmitters to be saved into the system memory.
Once this has been done, put the batteries in the second remote sensor and notice that a symbol of concentric arcs of a circle appears again - showing that the sensor is communicating with the logger. At the same time, the logger number [2] will be displayed on the main screen. Mark the logger [2]
Once this has settled down, repeat this for the third remote sensor, noting the communication symbol and the logger number [3]. Mark the logger [3]
The unit will then be receiving signals from each of the remotes.
Comment(s)
Recent Posts
